Setup guide

18 – English
SYSTEM SETUP
A. Point the remote at the speaker array and press the system power button.
B. Check that the power indicator on the speaker array is on (white), indicating the
system is on, and that the status indicator is off.
C. Put the ADAPTiQ
®
headset on your head making sure
the left and right sensors rest above your ears.
During the audio calibration the headset allows the
CineMate
®
1 SR system to hear exactly what you
hear.
D. Slide the ADAPTiQ connector cover off the end of the speaker array.
E. Insert the ADAPTiQ
®
headset cable into the ADAPTiQ headset connector until it is
fully seated.
The status indicator on the speaker array will glow green and the ADAPTiQ
calibration system will start automatically.
PowerStatus
If the Status indicator is blinking orange:
• There is no wireless connection between the speaker array and the
Acoustimass
®
module.
• See the Troubleshooting table in the back of the operating guide and
follow the instructions for correcting the problem of “No Sound.”
Sensor
ADAPTiQ
ADAPTiQ button ADAPTiQ headset connector
ADAPTiQ connector cover