Installation Instructions

6
Transformer tap setting
1. Position loudspeaker vertically with endcap closest to logo
facing up.
2. Pull forward on endcap to remove.
3. Set tap by turning the thumbwheel.
* Factory default ** NC: No Connection (do not use)
4. Press endcap into place — you should hear it click.
Note: If needed, you can remove the endcap and adjust the tap settings
after the loudspeaker is mounted.
Indstilling af transformerudtag
1. Placer højttaler lodret med endebolten tættest på logo,
der vender opad.
2. Træk fremad for at fjerne endebolten.
3. Indstil tap ved at dreje på tommelhjul.
* Fabriksstandard ** NC: Ingen forbindelse (undgå brug)
4. Tryk endebolten på plads - du skal høre et klik.
Bemærk: Hvis det er nødvendigt, kan du fjerne endebolten og justere
tappens indstillinger, når højttaleren er monteret.
Einstellung für Transformatorabgriff
1. Positionieren Sie die Lautsprecher vertikal, wobei die Blende,
die dem Logo am nächsten ist, nach oben weist.
2. Ziehen Sie die Blende nach
vorn, um sie zu entfernen.
3. Stellen Sie den Abgriff durch Dr
ehen der Einstellscheibe ein.
* Werkseitiger Standard ** NC: Keine Verbindung (nicht verwenden)
4. Drücken Sie die Blende wieder fest,
bis sie einrastet.
Hinweis: Bei Bedarf können Sie die Blende entfernen und den Abgriff
nach der Montage des Lautsprechers ändern.
Ajuste de las derivaciones
del transformador
1. Coloque el altavoz en vertical con el casquillo terminal más
cercano al logotipo mirando hacia arriba.
2. Tire del casquillo terminal hacia delante
para retirarlo.
3. Configure el terminal girando la ruedecilla.
* Ajuste de fábrica ** NC: Sin conexión (no utilizar)
4. Presione el casquillo terminal has
ta que se ajuste en su sitio.
Deberá oírse un clic.
Nota: Si es necesario, puede retirar el casquillo terminal y ajustar la
configuración las derivaciones después de montar el altavoz.
70V
NC**
12.5W* 25W 50W 100W
8Ω
25W* 50W 100W NC**
100V
70V
NC**
12.5W* 25W 50W 100W
8Ω
25W* 50W 100W NC**
100V
70V
NC**
12.5W* 25W 50W 100W
8Ω
25W* 50W 100W NC**
100V
70V
NC**
12.5W* 25W 50W 100W
8Ω
25W* 50W 100W NC**
100V
Removing End Cap and Accessing Tap Settings