Quick Start Manual

System Installation

2. Connect the wire end of one speaker cable to the terminals on the rear of the matching

speaker.

• Press the terminal tab on the back of the speaker and insert the marked wire (+) into the

red terminal and the plain wire (–) into the black terminal.

• Release the tab to secure the wire. Repeat this step for each of the five speakers.

Figure 9

Connecting the two-wire

cable to cube speakers

3. Connect each cable to the corresponding jack on the Acoustimass

module (Figure 10).

• Plug the blue connectors into the matching left front, center, and right front jacks.

• Plug the orange connectors into the matching left surround and right surround jacks.

Figure 10

Speaker connections to the

Acoustimass module

Note: You may find it more convenient to place the Acoustimass module upside down while

making connections. When done, place it on any of its sides but not on either end or top.

Terminal tab

Left, Right, or Center

printed on the red

collar on (+) wire

OUTPUTS TO

CUBE SPEAKERS

AUDIO

INPUT

POWER

FRONT SURROUND

100-120/200-240V AC

50/60 Hz

350W MAX.

Front speakers

Left Center Right

Surround speakers

Left Right

FRONT L

FRONT C

FRONT R

SURROUND L

SURROUND R

Acoustimass module connector panel