Quick Start Manual

BASIC SYSTEM CONNECTIONS
21
BASIC SYSTEM CONNECTIONS
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsItaliano SvenskaDeutsch NederlandsFrançaisEspañol
Completing the system power connections
Note: Bose recommends using a high-quality surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components in any system. A quality
suppressor can eliminate the vast majority of failures attributed to surges and may be purchased
at electronics stores.
Connect the two AC power (mains) cords in the following order:
1. On the connector panel of the Acoustimass
®
module, plug the appropriate end of the !
Acoustimass module power cord into the AC power jack (Figure 17).
2. Insert the other end of the power cord into the AC (mains) outlet.
Figure 17
Power connection for
the Acoustimass module
Acoustimass module
connector panel
AC (mains)
outlet
AC power jack
Power cord
3. If you have not yet plugged the small round connector of the media center power supply
cord into the DC POWER jack on the media center connection panel, do so now !
(Figure 18).
Figure 18
Power connection for the
media center
Fully extended power cord provides
remote control antenna
Media center
power supply
Media center connection panel
DC
power jack
AC (mains)
outlet
Power cable
Note: For dual voltage units (sold in certain areas), MAKE SURE the voltage setting on the
bottom of the media center power supply matches the local power rating (Figure 18). Check
with local electrical authorities if you are not sure of the appropriate power rating.
4. On the media center power supply, insert the small end of the AC power cable into the
power jack.
5. Plug the other end of the power cable into an AC (mains) outlet.