Quick Start Manual

BASIC SYSTEM CONNECTIONS

EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands ItalianoSvenska DeutschNederlands Français Español

Figure 21

Using the ADAPTiQ

calibration headset

AUX

L & R

Media center connection panel

Headset

2. Put on the headset so it rests above your ears. In this position, it can listen (as you would)

and take sampling measurements in your room during the ADAPTiQ audio calibration

process.

3. Follow the calibration process as directed on the TV screen.

Save the headset for possible future use

Keep the headset and discs together in their original carton and store them in a safe location.

You may want to customize your system again if you move it to another room or significantly

change the arrangement of the room by relocating furniture, the speakers, or the !

Acoustimass

module. You can reuse the ADAPTiQ system at any time.

Taking the next steps

This completes the basic connection of your system and TV.

Now you can:

• Install the TV on/off sensor, following instructions in the next section of this guide.

• Connect other components to the system, as instructed in “Optional Connections and

Additions” on page 26 of this guide.

• Use the system as it is now set up. Refer to your Operating Guide for details.