Quick Start Manual

BASIC SYSTEM CONNECTIONS
25
BASIC SYSTEM CONNECTIONS
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsItaliano SvenskaDeutsch NederlandsFrançaisEspañol
Installing the TV on/off sensor
The TV on/off sensor works with the system to automatically turn on the TV, as needed, when
another video source (DVD, cable/satellite box, etc.) is selected. If you choose not to use the
sensor, you need to turn on your TV separately.
Note:
For information on how to set the LIFESTYLE
®
remote to control your TV and work with the
sensor, refer to your Operating Guide.
For a larger TV, you may want a second person to help as you follow the steps below:
1. Plug the sensor cord connector into the TV SENSOR jack on the media center. !
If you are using a SCART adapter, plug the sensor directly into the pass-through !
jack provided on the adapter (Figure 15 on page 18).
2. Temporarily position the TV on/off sensor on the back of your TV.
Note:
DO NOT attach the supplied mounting strip until you have tested and activated the
automatic feature as explained below.
Figure 22
TV on/off sensor installed
on your TV
Rear of TV
TV on/off sensor
Sensor
mounting
strips
Media center
connection panel
TV SENSOR
jack
Note: Mount the sensor on the bottom rear of a projection TV chassis. Front projectors with a
separate screen may not work with the sensor.
3. Turn on your TV to test the sensor and activate the feature.
A. On the LIFESTYLE
®
system remote control, press System . !
Use the arrows to move around the on-screen menu and
press
Enter to make selections:
B. On the TV screen, move right to
Video and press Enter .
C. On the rear of the TV, move the sensor as needed, and notice when the on-screen !
TV Power Status!changes from TV not detected to TV ON.
D. Attach the included mounting strips, one to the sensor and one to the TV, and press
them together to hold the sensor in this effective position.
E. On the TV screen, move down to
TV Power, and select:
–
Automatic (for TV models that do not use a European-style SCART !
connector).
–
Euro Connector (for TV models that use a SCART connector).
F. Press
Enter to confirm this setting.
G. Press
Exit to leave the System menu. This completes activation.