Quick Start Manual

OPTIONAL CONNECTIONS AND ADDITIONS
27
OPTIONAL CONNECTIONS AND ADDITIONS
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsItaliano SvenskaDeutsch NederlandsFrançaisEspañol
Choosing digital audio
If your TV, VCR, tape deck, or AUX component has the proper output jacks, you can !
make a digital audio connection to the media center (Figure 23).
Figure 23
Digital audio and other
media center panel
connections
Coaxial Digital
Audio IN jacks
Optical Digital
Audio IN jack
Media center connector panel
• For a coaxial connection, use a 75-"hm cable with RCA connectors. Connect it to the !
Digital jack for that component: TV, CBL/SAT, VCR, or AUX.
• For an optical connection, insert an optical digital cable (with a square connector) into the
Optical IN on the media center rear panel.
Note:
To make digital recordings from a connected optical component, connect another optical
cable to the Optical OUT jacks on the media center rear panel.
Activating an optical connection
Before you can listen to a source connected to the Optical IN jack on the media center, you
MUST activate that connection:
1. Turn on your TV.
2. On the LIFESTYLE
®
system remote control, press System . !
Use the arrows to move around the on-screen menu and press
Enter to make selections:
A. On the TV screen, move right to
Media Center and press Enter .
B. Move down the menu to
Optical Source and press Enter .
C. Select the component that is connected to the media center using optical cable.
D. Press
Enter to confirm this setting.
E. Press
Exit to leave the System menu. This completes activation of your optical !
connection.