User's Manual

29
Reference
C
C
O
O
M
M
P
P
A
A
N
N
Y
Y
C
C
O
O
N
N
F
F
I
I
D
D
E
E
N
N
T
T
I
I
A
A
L
L
Replacing the remote control batteries
Slide the battery compartment door off of the back of the remote. Find the polarity markings
(+ and ) inside the compartment and install the batteries accordingly. Slide the cover back on
the remote and snap it closed.
Figure 13
Opening the remote con-
trol battery compartment
Troubleshooting
+
+
+
+
Battery
compartment
door
Battery
compartment
AA batteries (4)
Problem What to do
System doesnt do any-
thing
Make sure the power connector is inserted securely into the music center, the power
cord is inserted securely into the Acoustimass
®
module, and the power pack and power
cord are plugged fully into operating AC wall outlets.
Be sure to select a source (CD/DVD, AM/FM, etc.).
Unplug the media center power supply for a minute, then reconnect it. This allows the
unit to reset itself after a power surge or power interruption.
If the system is not responding, press Store, Erase, and On/Off (on the music center) at
the same time, to reset the system.
No sound Increase the volume.
Check to see if MUTE is lit on the display. If it is, press the Mute button on the remote
control to unmute the sound.
Make sure the audio input cable is rmly seated in the media center SPEAKER ZONE 1
jack and the multi-pin connector on the other end is rmly seated in the Acoustimass
module AUDIO INPUT jack.
Check speaker connections.
Turn the media center off for 10 seconds, then on again, to restore communication
between the music center and the speakers.
Check the connections for any external components. Make sure to select the correct
source for the desired input.
Be sure the disc is placed correctly, label-side up, in the CD tray.
Connect the FM and AM antennas.
No sound from center
speaker
Make sure the center speaker cable is connected at both ends.
Select 3- or 5-speaker mode.
Too much sound from
center speaker
In 3-speaker mode, press Surround to decrease center speaker volume.