Operation Manual
Table Of Contents
- Introduction
- Welcome
- Product overview
- Controls and indicators
- Connection panel
- System Setup
- Unpacking
- Removing/attaching the cover
- Mounting options
- Connecting the T1 to an L1TM model II power stand
- Connecting the T1 to an L1 model I power stand
- Connecting the T1 ToneMatchTM audio engine power supply (optional)
- Connecting the T1 to your computer
- Operating Instructions
- Optimizing input gain and output volume
- Using the Master volume control
- Muting a channel
- Muting channel effects
- Reading the T1 display
- Using the T1 rotary selector
- Editing the sound of a channel
- Selecting a ToneMatch™ preset
- Adjusting zEQ
- Adjusting Para EQ
- Using compressor/gate functions
- Using the KickGate
- Using modulation effects
- Adding delays
- Adding reverb
- Routing input signals to the Aux output
- Using the tuner
- Using global functions
- Selecting a type of reverb
- Using the Prefs utilities
- Loading and saving scenes
- Sharing a scene
- Bose scenes
- Factory Settings
- Singer/Songwriter
- DJ/Playback
- Drums and Bass
- The Works scene
- Factory Settings
- Care & Maintenance
- Cleaning
- Limited Warranty and Registration
- Accessories
- Troubleshooting
- Technical information
51
CARE & MAINTENANCE
SvenskaItalianoFrançaisEspañolDeutschDanskEnglish Nederlands
Not hearing any effects. • Check that you pressed the correct CH Edit button.
• Make sure the FX Mute button is not pressed for the channel in question.
T1 not responding to
control knobs.
• Turn off the audio engine. Wait 30 seconds and turn unit on again.
Master volume control has
no effect.
• Verify that the Master output is configured for Post Master Volume operation in the Prefs menu under Master
Out.
With nothing plugged into
the T1 input connectors, a
slight hum or buzz is heard
from the L1 system.
• Plug the T1 and the L1
TM
power stand into the same AC (mains) outlet.
• Using an AC outlet tester, test the AC outlet that the T1 and/or the L1 power stand is plugged into for reversed
or open (hot, neutral, and/or ground) contacts.
• If using an extension cord, make sure that the cord is also tested as above.
Too much (or not enough)
bass, mid-range, or high
frequencies.
• Make sure there is no unwanted zEQ or Para EQ equalization applied.
• Verify that you have selected an appropriate ToneMatch
TM
engine preset for your microphone/instrument. If you
do not want to use a ToneMatch engine preset, make sure ToneMatch is set to Flat in the Utility category.
Poor-sounding playback of
a stereo recording using a
CD player, MP3 player, or
other such device.
• Connect the left channel of the device to T1 input channel 4 and the right channel to T1 input channel 5.
Channels 4/5 are designed for line-level inputs.
• Disable any extended bass or EQ features when using CD or MP3 players.
• If you are using recording software on a computer, check the software requirements. You may need to configure
the software settings for 48kHz/24-bit operation.
If using the T1 with an L1 model I system:
•Do not use a female
1
/8" stereo-to-male ¼" stereo adapter when connecting a portable device to an input
channel on the L1 model I power stand. The L1 model I input channels use a monaural (TS) connection. Use a
stereo-to-monaural adapter.
Problem What to do