Instructions / Assembly

2006 © Rowlinson Garden Products Ltd
ROWLINSONGARDEN PRODUCTS LIMITED
Unit 2 Green Lane
Wardle, Nr.Nantwich
Cheshire
CW5 6BN
Help Line (Normal Office Hours) 01829 261 121
English SS054A
No. Components Qty.
1 Upright posts 4
2 Trellis sections 2
3 Cross beams 2
4 Corner braces 4
5 Rafters
5
No. Fixing kit Qty.
6 60mm screws 34
12
3
Before assembly
•
We recommend that time is taken to read the instructions before
starting assembly, then follow the easy step by step guide.
The instruction sheet is only a guide to the assembly.
Certain items may not be shown to scale.
•
Check all components prior to assembly
•
This product should be assembled by no less than two people.
•
Never attempt to erect the assembly in high winds.
•
Drill all components where indicated.
Recommended tools for assembly
•
Cross head screw driver
•
Drill with 4mm drill bit
•
Tape measure
•
Step ladder
x 2
60mm
We constantly improve the quality of our products, occasionally the
components may differ from the components shown and are only correct at
time of printing. We reserve the right to change the specification of our
products without prior notice.
3.
Corner braces
Drill 2 holes in each corner brace as shown,fix a brace between each leg and
cross beam as shown using 2 x 60mm screws per support.
1.
Arch apex sections
Position a trellis between 2 upright legs. Position the trellis so that it is
approximately 80mm from the top. It is important to ensure the correct
orientation of the rebate at the top of the posts as shown in the diagram.
Secure the trellis to the legs using 4x60mm screws.Create a second assembly
in the same way.
2. Cross beams
Fit the cross beams into the rebates at the top of the uprights as shown,
ensure that all the legs are the same distance from the ends of the cross
beams secure using 2 x 60mm screws per leg.Screw through the legs into the
cross beams as shown.
80mm
Drill
It is recommended
to drill pilot holes
in the trellis frame
for these screws
with a 4mm drill bit
before assembly.
Drill
It is recommended to drill
pilot holes for these
screws with a 4mm drill bit
before assembly.
Drill
Assembly Instructions
Arch
4
5
60mm
60mm
Drill
60mm
60mm
4. Rafters
Slot the rafters onto the cross beams, ensure that the rafters are all evenly
spaced and secure them down using 2 x 60mm screws per rafter.
It is recommended to drill pilot holes
for these screws with a 4mm drill bit
before assembly.
Drill