Use and Care Manual
GA: 4390813_1
IMPORTANT - Assembly Instructions – USA
A. Before commencing assembly check parts in box with illustrations on components
page and thoroughly read the assembly instructions. Suggestions regarding siting options
can also be found at www.trimetals.co.uk.
B. In the unlikely event that this product has been delivered damaged, there are any
parts not included or you are having difficulties with assembly please contact Bosmere Inc,
North Carolina, bosmereusa@ctc.net. DO NOT CONTACT THE RETAILER. Bosmere Inc will
endeavour to correct any problems as quickly as possible.
C. A firm, level and flat surface is required as a base for the product. The product must
be secured / anchored to a hard base (e.g., concrete or paving slabs). The product may not
function properly if the base is not flat and level.
D. Do not assemble in windy conditions. If weather conditions change during assembly
it is recommended that you stop and make the unfinished construction safe by temporarily
anchoring the assembled parts to the base until conditions improve. This is to avoid
personal injury to yourself or others and to protect the product panels from damage.
E. Extra care should be taken to avoid cuts and abrasions from exposed edges during
assembly. We strongly recommend the use of protective gloves, heavy duty long sleeved
clothing and protective glasses.
F. We recommend that two adults work on the assembly. Children should not assist
with the assembly of the product and should be kept clear of the area when assembling the
product.
G. We recommend that this product be only used by adults.
H. Precautions should be taken when the products are being used in exposed areas
subject to high wind speeds. Care should be taken when they are opened to avoid damage.
I. Do not locate the product where accumulations of water, snow or ice may drop on it
from a height.
J. It is your responsibility, to contact the local authorities to enquire if planning
permission is required.
K. For additional weatherproofing we recommend the use of a mastic type sealant that
can be used to create a seal between panels, as well as the product and the ground.