User Manual

3
INSTALLATION (CONT.)
INSTALLATION
DIAGRAM
- Only use speakers with 4 ohm impedance.
- The maximum current of the Amp Remote trigger is 200mA.
Wiring Connections
!
Removal of the Main Unit
1. Remove the metal strap from the main unit.
2. Remove the plastic trim out from the main unit.
3. Insert a bracket key into the left and right side of the main unit and draw the unit out of
the mounting sleeve.
HEX BOLT
SPRING WASHER
PLAIN WASHER
TAPPING SCREW
HEX NUT
DASH BOARD
METAL MOUNTING STRAP
CONSOLE
MOUNTING SLEEVE
WIRING DIAGRAM
CAUTION
+12V DC
NEGATIVE
GROUND
15
White:Front Left PRE-AMP Output
White: Rear Left PRE-AMP Output
Red: Front Right PRE-AMP Output
AUX-Left input
AUX-Right input
Red: Rear Right PRE-AMP Outpt
Radio Antenna
15A
ACC + (Red)
GND - (Black)
ANT + (Blue)
Power B+ (Yellow)
Green
Purple
Rear Right
Speaker
Front Right
Speaker
Rear Left
Speaker
Front Left
Speaker
Purple/Black
Green/Black
White
White/Black
Gray
Gray/Black