Instruction manual

2. C
ommon Operation
1. To turn on/off the unit
Under power off mode, press the POWER button to turn on the unit.
Under power on mode, press and hold the POWER button on the front panel
or briefly press the POWER button on the remote control to turn off the unit.
2. To select function mode
Press the MODE button to select TUNER, DISC
(After inserting a disc), USB (After inserting a
USB storage), Card(After insertinga MMC or SD
card),AV IN,AUX,BLUETOOTH or SETUPmode.
Press and hold the BAND button to turn on
shift then rotate the VOL knob or the
direction
bu
ttons to select function mode; you can
also use the direction buttons to select
function mode and press OK to confirm.
During playing , select the to up to the main Menu.
Press and hold the MODE button the display can be turned off but the unit
keeps working, when we press whatever button it returns on.
Note: This unit has front and rear USB. Only one will work at a time.
3. To adjust sound level
Rotate the VOL knob or press or hold the + or - button to directly adjust the
volume level.
4. To mute sound
Press the MUTE button on remote control to turn on/off MUTE mode.
Briefly pressing the POWER button on the front panel also can turn on/off
MUTE mode.
5. To display the time
Press the CLK button on remote controller to display clock time on the small
monitor of the front panel in DISC/USB/SD-MMC modes, while under RADIO
mode it is always displayed.
6. To select a preset EQ mode
Press the EQ button to select the preset music equalizer curves: FLAT,
CLASSIC, ROCK, POP, EQ OFF . The sound effect will be changed.
7. To remove the front panel
Press the REL button on the front panel to detach the front panel from the
unit, then you can remove the front panel.
8. To turn on/off LOUDNESS mode
Press the LOUD button to turn on/off LOUDNESS mode.
When turning on LOUDNESS mode, it will enhance bass level immediately
when the bass is not enough.
Mode
Menu
4
.
25.4 VIDEO SETUP
BRIGHTNESS
It is for adjusting the brightness of the video output.
CONTRAST
It is for adjusting the contrast of the video output.
SATURA
TION
It is for adjusting the saturation of the video output.
HUE
It is for adjusting the hue of the video output.
4.25.5 SPEAKER SETUP
DOWNMIX
It
is for selecting your desired sound effect when there is no center speaker
and subwoofer. There are 3 modes: LT/RT, STEREO, VSS.
LT/R
T: When playing a media with
s
t
ereo effect, choose theitem, so it will
output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose the item, when playing a media recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.