Preface Thank you for purchasing this car audio product. Please read this manual carefully before operating this car audio product. Please keep this manual for future use. It will be helpful to you if you are encounter any operational problem. Selecting fine audio equipment is only the start of your musical enjoyment. Now it is time to consider how to maximize the enjoyment you will get from knowing how to work your new car stereo receiver.
LOCATION AND FUNCTION OF CONTROLS 17 13 14 2 SCN LOUD 9 10 1 4 MUTE REL 5 15 VOL LOC - ST 6 BND 11 + SEL APS INT MODE CLK 16 7 8 1 2 RPT AUX RDM 3 4 5 6 PWR 3 18 21 12 20 19 22 24 23 1. RELEASE BUTTON Press the REL button to flip down the front control panel.
b) When pressed and hold for 2 seconds, it is activated as cyclical mode of following functions for user’ s selection. ->BEEP (ON/OFF) -> USER SET(FLAT/CLASSIC/ROCK/POP) ->SUBW(ON/OFF) -> VOL(LAST/DEFA) ->STEREO/MONO(only for FM mode)->CLK(ON/OFF)->CLK(12/24)mode. After selecting the desired mode, rotate the VOL knob to select one setup item of the desired mode. BEEP ON/BEEP OFF BEEP ON mode: The beep is generated when any key is pressed. BEEP OFF mode: The beep sound is disabled.
TROUBLE SHOOTING Before using the check list please make all the connections first. If you still have questions after going through the checklist, please consult your local customer service representative. Common Symptoms Cause Solution The car ignition is switched off. If the power supply is properly connected to the car accessory, switch the ignition key to " ON " or " ACC " . The fuse has blown. Replace another fuse according to the wiring diagram. There is no power. The CDs cannot be loaded.
12. PRESET STATION MEMORY AND TOP/>||, INT, RPT, RDM BUTTONS a) During radio mode: Go to any preset station by pressing one of the 6 preset station buttons (1-6). If one of these buttons is pressed for more than 2 seconds, the station currently being listened to will be memorized into the selected preset button. b) During disc, SD or USB mode: 1) Press the TOP/ >|| button briefly to interrupt the playback of the disc, SD/MMC or USB. Press again to resume normal playback of the disc, SD/MMC or USB.
17. SCAN BUTTON Press the SCN button to scan the radio frequency. If a valid signal has detecte the current frequency will be hold and blinking for 5 seconds, then press SCN again to stop scan and remain the current frequency; otherwise, the radio will go on to scan the other radio frequency 5 seconds later. INSTALLATION INSTALLATION METHOD This is an anti-theft installation method. The main unit wears a METAL MOUNTING SLEEVE.
MAINTENANCE OF REMOTE CONTROL OPERATION OF REMOTE CONTROL 1. Power On/Off 12 An insulation tag was installed in your remote by the manufacturer to prevent the battery from draining. Removing the tag from the remote before using. 4 2. Mute Button 3. Loudness Button 1 4. Level/MENU UP Button 2 7. MO/ST Button 9 14 - 7 BAND LOC LOUD 3 INT RPT 2 3 5 6 A.P. MODE 15 17 16 8. A.P Button 19 9. Band Button 6 ST CLOCK 10 11 SELECT 8 5. SEL/MENU Button 6.