User manual

Page 31 of 51 Vetta Head Assembly Instructions Rev D1
There are (6) encoders knob treatments (30-27-0042) used on this product. They are to be
placed in the holes indicated below. Insert them onto the front (or overlay side) of the chassis .
1 washer is being left off the assembly, as shown below.
b) Attach the Bezels
Once the overlay is in place, the next step is to attach the bezels. There are two bezels, the
large LCD bezel (30-27-0034), and the small LCD bezel (30-27-0031). The bezels have
locking fingers that will snap into place though the cutouts in the chassis cover. Apply smooth
even pressure to the top of each bezel until it snaps into place.
The Large Bezel is finally secured with (4) Screws #30-00-0025 4-40 x 3/16” lg PPH, torque 4
in/lbs, and 2 Retaining clips (#30-51-0093) as shown.
Install shoulder washers to these 6 locations
Each treatment has a set of locking fingers that snaps into
place. Make sure that each treatment sits flush with the
surface of the cover.
Overlay side of the
chassis
DO NOT
INSTALL this
one.
Due to the
rotation stiffness.