User manual

Page 41 of 51 Vetta Head Assembly Instructions Rev D1
Completing the Electrical Chassis
ITEM QTY LINE6 PART NO REV DESCRIPTION
1 1 N/A (REF ONLY) X0 ASSY, CHASSIS - COMPLETE
2 1 N/A (REF ONLY) X0 ASSY, CHASSIS COVER
3 2 30-00-1012 N/A SCREW #10-32 X 1/2 PHILLIPS PAN ZINC
4 8 30-00-0607 N/A SCR 6-32 x 7/16 LG PHILLIPS PN
5 2 30-03-0001 N/A WASHER #10 EXTERNAL TOOTH LOCKWASHER ZINC
x 2 30-51-0095 N/a CHASSIS BRACE (NOT SHOWN ABOVE)
a) Attach the Chassis Cover Assembly to the Sub-Chassis
Before proceeding, verify that all cable assemblies are properly attached. Connect the cable
assemblies between the cover and chassis as described in the previous section. Connect the
guitar cable from the main board up to the guitar jack PCB on the cover. Connect the main
ribbon cable from the main board up to the UI-left panel. Connect the cable for the main switch
the power supply and to the power switch.
2 Chassis Brace’s are assembled at this point, to strengthen the assembly.
Refer to this
graphic throughout
this section for aid
in locating the
parts discussed.