User manual

Page 45 of 51 Vetta Head Assembly Instructions Rev D1
a) Assemble the Handle Bracket
Center the handle strap into the recesses of the top handle bracket – NOTE ORIENTATION
OF THE GROOVES IN THE STRAP (see below). Hold the front handle bracket against the
front of the cabinet as shown below. With the strap held in the recess, place the Top handle
bracket onto the Front handle Bracket..
ASSURE ALLIGNMET BETWEEN EDGES OF
TOP AND FRONT BRACKET –SEE BOLD NOTE BELOW
. At this point fasten the 2
Top Bracket using #10-32 machine screws only. Tighten to a torque of 8-10 in/lbs.
Note orientation of
handle strap with
groves on top
Note that these 2 edges align
when handle bracket pieces
are properly mounted.
#10 x 1-inch oval head Phil
wood screw (30-00-0023)
#10-32 oval head machine screws
(30-00-1032)
Top handle bracket
30-51-0074
Front handle bracket
30-51-0075
Handle strap assy
(30-57-0580)
Vetta disclaimer sticker.
P/N 40-25-0150