User manual

Page 48 of 51 Vetta Head Assembly Instructions Rev D1
e) Attach the Knobs
The next step in assembling the cover sub-assembly is placing the knobs on the component
stems. The knobs are standardized across multiple Line 6 products.
The large encoder knob also has a spacing finger. DO NOT REMOVE the spacing finger from
the encoder knob (
30-27-0027
).
Check to ensure that the small encoder knob has been chosen correctly. It must NOT have a
white indicator line that shows its orientation. (Line 6 stocks a very similar small potentiometer
knob that has a line).
Simply orient the knob such that the D-shaped hole matches the stem of a component and slide
it down until it rests on the step in the component shaft. The knobs are not to bottom out on the
face of the product or the knob treatments.
30-27-0025 30-45-2000
30-27-0027
30-27-0024
Large Encoder pot shafts have a strip of tape applied,
from the Flat surface, across the top. (Not shown here).
#30-65-0004 (1 on each).
This prevents the knobs from coming loose.