User manual

All 16 blocks on the small left LCD should fill.
Press
GATE
once to advance to Test #5.
5.
Graphic LCD Test #5
Press
COMP
button to start test.
The large right LCD should fill and then clear.
A vertical line will run from right to left on the right LCD.
Then a horizontal line will run from bottom to top.
Press
GATE
to advance to test #6
6.
Encoder Test #6
Press the
COMP
button to start test
Rotate all 7 black encoder knobs. The large right LCD
should display changing numbers as each of the encoders
is turned.
Press
REVERB
to exit test.
Press
GATE
button to advance to test #7.
7.
POTS test #7
Press the
COMP
button to start test.
Rotate all 10 silver pots. The large right LCD should display 000
when pot is fully to the left and 127 when fully to the right.
Press
REVERB
to exit test.
Press
GATE
to advance to test #8
8.
MIDI Test
A midi cable must be connected from the Midi In port to the Midi Out
port for this test.
After midi cable is in, press
COMP
to begin Midi Test.
Large right LCD will display test results (pass or fail/error)
Press
REVERB
to exit test.
Press
GATE
to advance to test #9
9.
FB Test
This test requires a special RJ45 loopback connector. If you do not
have this connector, simply press
GATE
to advance to next test.
With the loopback connector connected, hit the
COMP
to begin test.
Large right LCD will display test results (Pass or fail/error)
Press
REVERB
to exit test.
Press
GATE
to advance to next test.