User manual

Page 2 of 51 Vetta Head Assembly Instructions Rev D1
Vetta Head Mechanical Assembly Instructions
Table of Contents
Forward and Notes........................................................................................................................1
Cabinet Assembly ..........................................................................................................................3
a) Attach the Corners and Rubber Feet..............................................................................4
b) Attach foam strips to cabinet...........................................................................................5
c) Test and inspect the Cabinet Assembly ..........................................................................5
Power Amp Assembly.................................................................................................................... 6
a) Bend Power Components.................................................................................................6
b) Attach power components and pads ...............................................................................7
c) Attach the Power Amp PCB to the Heat Sink................................................................ 9
d) Secure PCB Assy with the device clamps. ...................................................................... 9
The Power Supply Assembly ......................................................................................................11
a) PCB Assembly Notes (See Figure 1): ............................................................................ 12
b) Assemble Power Components to Heat Sink (See Figure 2):........................................ 13
c) Attach Heat Sink / Power Device assembly to PCB..................................................... 14
d) Assemble PCBA & Heat Sink Assembly to Power Supply Bracket:.......................... 15
The Chassis Assembly .................................................................................................................16
a) Attach the Expansion Slot Cover Plate......................................................................... 17
b) Insert the Line Filter board ........................................................................................... 17
c) Insert the Power Supply PCB........................................................................................18
d) Attach the Speaker Output PCB................................................................................... 18
e) Insert the Power Amp Assembly................................................................................... 19
f) Attach Foam Block to the chassis and the Main Board PCB ....................................20
g) Inspect the Completed Sub-Assembly...........................................................................22
The User Interface (UI) PCBs....................................................................................................23
a) Place Standoffs and Displays.........................................................................................24
b) Pre-assemble Button Assemblies...................................................................................25
c) Place Button Assemblies.................................................................................................26
d) Inspect the UI PCBs........................................................................................................27
The Chassis Cover Assembly......................................................................................................28
a) Attach the Overlay, foam pads & shoulder washers...................................................29
b) Attach the Bezels.............................................................................................................31
c) Position Keycaps.............................................................................................................32
d) Attach the UI PCBs and Guitar Input Jack to the Chassis Cover .............................33
e) Inspect the Completed UI Panel Sub-Assembly...........................................................34
Cable Assemblies .........................................................................................................................35
a) Connect the Cable Assemblies & tie wrap positioning................................................36
b) Set the voltage jumpers ..................................................................................................40
Completing the Electrical Chassis..............................................................................................41
a) Attach the Chassis Cover Assembly to the Sub-Chassis w/braces .............................42
Completing the Unit ....................................................................................................................44
a) Assemble the Handle Bracket........................................................................................45
b) Attach the Line 6 Logo................................................................................................... 46
c) Insert the Chassis into the Cabinet. ..............................................................................46
d) Place the Bezel Lenses ………………………………………………………………… 47
e) Attach the Knobs ............................................................................................................48
d) Set shipping configuration .............................................................................................49
Test and Inspect the Completed Unit . …………………………………..50
Pack-out List…………………………………………………………..…..51