User manual

Page 5 of 51 Vetta Head Assembly Instructions Rev D1
b) Attach foam strips to cabinet.
Attach foam stripping (30-63-4001) to the full length of the inside surface of the cabinet.
Apply 2 stacked layers to the inside of front face as shown in the figure below.
c) Test and inspect the Cabinet Assembly
When the cabinet assembly is complete, check it for any defects in craftsmanship. Things to
pay attention to include but are not limited to:
• Tearing or damage to the vinyl covering.
• Flush insertion of all corner guards and screws.
Inside of front face
Overlay 2 strips of foam tape
(30-63-4001)
Overlay 2 strips of foam tape
(30-63-4001)
Approximate positioning
for foam tape