User manual

Page 26 of 51 Vetta Head Assembly Instructions Rev D1
Button Assembly Part No. Reference Chart
Amp select Channel select Edit Select
Rubber Pad
50-00-0007 50-00-0008 50-00-0009
Isolation Frame
30-27-0004 30-27-0003 30-37-0001
Keycap Array
50-00-0039 50-00-0042 50-00-0043
c) Place Button Assemblies
Insert the button assemblies into the PCB as shown in the graphic below. Each button frame
has a set of alignment pins that will guide it to its proper location. A pair of locking fingers
will snap into routed holes in the board. Ensure that each frame is securely locked into place
and is situated flush with the face of the PCB.
Note: The Mylar
keycap assemblies do
not lock to the
isolation frames and
may be set aside until
it is time assemble the
chassis cover.
Amp Select
Button assembly
Channel Select
Button Assembly
Edit Select
Button Assembly
These attach to UI – left board
(see diagram on page 22)
This attaches to UI –right
board