Instruction manual

The essentials
37
3 Select device with [▼].
4 Confirm with [OK].
– The display shows and a brand name.
– The keys that you can use are flashing.
5 Select the brand of the device with [▼ ] and [▲].
– If the brand of your device is not in the list, you can select any
other brand.
6 Confirm with [OK].
7 Hold down [] until the device responds.
– The display shows .
8 Aim the remote control at the device.
– The remote control starts sending all known “Off” codes one
after the other. Each time the remote control sends a code,
the display shows the following: “TEST 01, 02, 03” etc.
9 When the device responds, release [] immediately.
– The remote control has now found a code which works with
your device. “SETUP OK” appears on the display.
– If the device does not respond and “LIST END” appears, no
code was found for the device.