Instruction manual

The Merten CONNECT radio system
38
The Merten CONNECT radio system is an intelligent, flexible radio
network in which the individual devices do not only transmit and
receive one-way signals but also communicate with one another.
The system uses functions such as routing and alternative radio
transmission paths (e.g. in the event of temporary faults).
The device-specific addressing of the radio commands also enables
multiple radio systems to operate side by side.
This range of functions makes the Merten CONNECT radio system
very reliable, interference-resistant and flexible.
To control building functions by radio (e.g. switch lights on and off or
open and close shutters), you first need to set up a CONNECT radio
system and program in and configure the various devices (using the
“learning” mode).
The CONNECT radio remote control gives you a number of simple
and convenient options for setting up a CONNECT radio system and
configuring devices.
When configuring a Merten CONNECT radio system, there are a
number of special points to be aware of.
Prerequisites:
• All receivers must be installed and connected in their final
installation locations.
• Connect a corresponding load (e.g. lights, shutters) to the
receivers (some receivers use the connected devices to confirm
commands during the learning/configuration procedure).
• You must be able to set the devices to the learning mode/status:
The learning mode/status is activated with a triple click: briefly
press the operating surface/programming button or sensor
surface (depending on the device) three times in a row.
Tap the operating surface or programming button three times for
programming at approximately the same speed you would use for
a double-click (or triple-click) on a computer mouse (three times in
approx. 1.5 seconds). The learning mode/status is indicated on
devices with LEDs by a flashing light.
The Merten CONNECT radio system
Configuring a
Merten CONNECT radio system