Instruction manual

ManualsBrandsBoss Audio Systems ManualsAutomotiveCXX1604

Configuring a Merten CONNECT radio system

Notes on configuration using the remote control

When configuring a Merten CONNECT radio system with the

remote control, there are a number of special points which you

should note.

• If you want to operate multiple receivers with one key, all devices

linked must support the same functions. For example, you cannot

switch one receiver on and off and dim another receiver with the

one key.

• When creating the connection between installed push-buttons

and receivers using EASY Link, the receivers are first programmed

to one push-button only. The connections for that radio push-

button are then copied to additional radio push-buttons as desired.

The additional radio push-buttons are not programmed to the

receivers.

These push-buttons then control the same functions on the same

receivers as the first radio push-button.

You can copy the connections from one radio push-button to up to

4 additional radio push-buttons.

If you program in more receivers on the first radio push-button

after the fact, you must copy the connections to the other push-

buttons again.

Switching to configuration mode for the Merten

CONNECT radio system

This section explains how you

access the configuration mode

for the devices in the Merten

CONNECT radio system and

how you exit that area.

1 Press the SETUP key [ ] for three seconds.

– Wait until the status display goes out again.

– The remote control is in the configuration mode for Merten

devices.

– The display now shows EASY CONNECT? and the upper left

corner shows .

2 Use the cursor keys [▼] and [▲ ] to select the other menu

items.

3 To exit the configuration mode again, press the SETUP key

[] for three seconds.

Navigating in configuration mode

This section explains how you

move the cursor around in the

menus in the configuration

mode, and how to select and

activate/confirm individual menu

items.

– Use the cursor keys [▼] and [▲ ] to select the individual

menu items.

– Activate/confirm your selection with [OK].

– Use the cursor key to go back one menu level.