Instruction manual

EASY Connect
42
You can use this function to
remove memory areas which
are no longer used.
Deleting memory areas
1 Switch to configuration mode.
2 Activate EASY CONNECT?.
3 Activate the memory area which you want to delete.
4 Activate DELETE ROOM?. .
– The display shows SURE?.
5 Confirm with [OK] or cancel the procedure with [].
– After confirmation, the display shows the name of the next
memory area.
– The selected memory area is removed from the list.
6 Exit the setup mode.
This section shows you how to
program in a radio receiver onto
one of the numeric keys on the
remote control, using the
“learning” function.
The receivers must all have the
same functions. For example,
you cannot switch one receiver
on and off and dim another
receiver with the one key.
Tip: First radio receiver on the
first numeric key, second radio
receiver on the second key, and
so on. Make a note of the
assignment of the numeric keys
so that you do not delete a key
or assign it to more than one
receiver accidentally.
Linking radio receivers to a numeric key
1 Switch to configuration mode.
2 Activate EASY CONNECT?.
3 Activate the desired memory area.
4 Activate the function CONNECT KEY?.
– The display shows PRESS 1TO9/SCENE.
– Then select one of the numeric keys (1 to 9).
– The display shows WAIT RCV.
– Activate the learning mode on the radio receiver within 15
seconds (by pressing 3x): the remote control establishes the
connection to the receiver automatically.
When the connection is established, OK appears briefly and the
display then changes back to CONNECT KEY?. Repeat step 4 for
all radio receivers you want to program onto the same numeric
key (max. 12).
If the connection is not established successfully, ERROR appears
on the display. Repeat step 4.
5 Exit the setup mode.