Instruction manual

EASY Connect
44
A scene switches several radio
receivers to pre-defined states
at the press of a single button:
e.g. switching a number of
lamps to different brightness
levels.
This section shows you how you
can set up a scene.
Setting up scenes
1 Switch to configuration mode.
2 Activate EASY CONNECT?.
3 Activate the desired memory area.
4 Activate the function CONNECT KEY?.
– The display shows PRESS 1TO9/SCENE.
– Select one of the scene keys (scene 1 to 3).
– The display shows WAIT RCV.
– Set the first radio receiver to learning mode (by pressing 3x):
the remote control establishes the connection to the radio
receiver automatically.
When the connection is established, OK appears briefly and the
display then changes back to CONNECT KEY?. Repeat step 4 until
all receivers for the scene are programmed in. Always program in
the receivers one after the other.
If the connection is not established successfully, the display
changes back to CONNECT KEY?.
5 Exit the setup mode.
6 Set the various receivers for the scene to the desired settings
(on the device, not via the remote control!) (e.g. desired
brightness; On, Off).
7 Press the scene key for at least three seconds; the settings of
the receivers will be transferred.
Your pre-defined scene is now set up. Every time you press the
corresponding scene key, the receivers in that scene are activated
with the saved settings.