Instruction manual

EASY Link
45
EASY Link allows radio receivers
to be linked to radio push-
buttons. Those radio receivers
can then only be operated via
the radio push-buttons which
you have programmed in this
way.
If you want to operate them via
the radio remote control as well,
the radio receivers must be
programmed into a key on the
remote control separately.
Linking radio receivers to radio push-buttons
1 Switch to configuration mode.
2 Activate EASY LINK?.
3 Activate ADD?.
4 Activate CONNECT RCV?.
– The display shows PRESS 1/3.
– Press numeric key 1 or 3.
If you are programming in the radio receiver on a 1-gang radio
push-button, press numeric key 1 only. With a 2-gang radio
push-button, numeric key 1 corresponds to the left rocker and
numeric key 3 to the right rocker.
– Activate the learning mode on the radio receiver (by pressing
3x).
– The remote control establishes the connection to the radio
receiver automatically.
– The display shows OK (ERROR if the connection is not
established successfully).
– Repeat step 4 for all radio receivers which you want to link
to the radio push-button (max. 12).
5 Activate WRITE PB?.
– The display shows WAIT PB.
– Activate the learning mode on the radio push-button (by
pressing 3x).
– The remote control establishes the connection to the radio
push-button automatically.
– Once the connection is established successfully, OK appears
on the display.
– The radio receivers can now be operated using the radio
push-button.
6 Exit the setup mode.
EASY Link