Instruction manual

EASY Link
46
You can use this function to
program in another radio
receiver on a radio push-button
where one or more radio
receivers have already been
programmed in. You can
program in up to 12 receivers
per push-button.
The receivers must all have the
same functions. For example,
you cannot switch one receiver
on and off and dim another
receiver with the one push-
button.
Linking an additional radio receiver to a radio
push-button
1 Switch to configuration mode.
2 Activate EASY LINK?.
3 Activate MODIFY?.
4 Activate READ PB?.
– The display shows WAIT PB.
– Activate the learning mode on the radio push-button (by
pressing 3x).
– The remote control establishes the connection to the radio
push-button automatically.
– Once the connection is established successfully, READ PB?
appears on the display.
– If the connection is not established successfully, ERROR
appears on the display.
– Repeat step 4 for all radio receivers which you want to link
to the radio push-button (max. 12).
5 Activate CONNECT RCV?.
– The display shows PRESS 1/3.
– Press numeric key 1 or 3.
If you are programming in the radio receiver on a 1-gang radio
push-button, press numeric key 1 only. With a 2-gang radio
push-button, numeric key 1 corresponds to the left rocker and
numeric key 3 to the right rocker.
– Activate the learning mode on the radio receiver (by pressing
3x).
– The remote control establishes the connection to the radio
receiver automatically.
– If the connection is established successfully, the display
shows OK, and if the connection is not established
successfully it shows ERROR. Repeat step 5.
6 Activate WRITE PB?.
– The display shows WAIT PB.
– Activate the learning mode on the radio push-button (by
pressing 3x).
– The remote control establishes the connection to the radio
push-button automatically.
– Once the connection is established successfully, OK appears
on the display.
– The additional radio receiver can now be operated using the
radio push-button.
7 Exit the setup mode.