Instruction manual

Options
53
IR AV devices
Programming in an IR AV device on the remote
control
You can set up the remote control for operation of up to five devices:
1 Switch on the device which you want to set up for the remote
control.
– If the device is a DVD player/recorder or video recorder, insert
a disc or tape and start playback.
2 Switch the remote control to setup mode:
– Press [SELECT] for three seconds.
– The display shows ,
and “CONFIG DEVICE ?”.
– The background lighting is switched on.
– The keys that you can use are flashing.
3 Confirm with [OK].
The remote control is now ready to be set up for operation of your
device.
4 Select device with [▼].
5 Confirm with [OK].
– The display shows and a brand name.
– The keys that you can use are flashing.
6 Select the brand of the device with [▼ ] and [▲].
– If the brand of your device is not in the list, you can select any
other brand.
7 Confirm with [OK].
8 Hold down [] until the device responds.
– The display shows .
9 Aim the remote control at the device.
– The remote control starts sending all known “Off” codes one
after the other. Each time the remote control sends a code,
the display shows the following: “TEST 01, 02, 03” etc.
0 When the device responds, release [] immediately.
– The remote control has now found a code which works with
your device. „SETUP OK” appears on the display.
– If the device does not respond and “LIST END” appears, no
code was found for the device.
Options
Device Shown on display
TV TV
AMP (hifi receiver/amplifier) AMP
SAT (satellite TV receiver) SAT
DMR (Digital Media Receiver) DMR
DVD/VCR (DVD player/video recorder) DVD/VCR