Instruction manual

Options
54
Then check whether all device functions can be carried out using the
remote control:
– If they can, the remote control is ready for operation of the
device.
– If they cannot, repeat the programming procedure: select the
device, activate “MODIFY?” and repeat from step 3.
The previous code, which did not work completely, is not
used again in the second programming attempt. As soon as
your device responds to the (new) code, release []
immediately.
If you want to set up the remote control to operate other devices,
you must switch the remote control back into setup mode: press
[SELECT] for three seconds. Repeat the setup procedure from step
3.
|
If, after several attempts, a device still does not respond or does not
respond to all button commands, a matching code for the device
was not found.
Activating/using CODE direct
1 Press [SET UP] for three seconds.
– The display shows ,
and “CONFIG DEVICE ?”.
– The background lighting is switched on.
– The keys that you can use are flashing.
2 Using [▼] and [▲], select the option “ENTER CODE”.
3 Use the numeric keys to enter the code.
4 Press [OK].