User’s Manual HS-IR WIRELESS INFRARED AUDIO HEADPHONE SYSTEM WITH TWO HEADPHONES AND TRANSMITTER HP10 WIRELESS INFRARED HEADPHONES HS-1R WIRELESS INFRARED AUDIO HEADPHONE SYSTEM WITH TWO HEADPHONES AND TRANSMITTER HS-1R WIRELESS INFRARED HEADPHONES 03.2011 BOSS Audio Systems 3451 Lunar Court • Oxnard, CA 93030 www.bossaudio.com tech support: www.bossaudio.com/support 800.999.
USER’S MANUAL page HS-IR CONTENTS Wireless Infrared Headphone System (Two Headphones and Transmitter) 2 General precautions 2 Safety precautions HP-10 2 Installation precautions Wireless Headphones (for use with BOSS HS-IR and BOSS Monitors with Infrared Audio Transmission) 2 What is included? 3 Headphone controls and features 4 HS-IR features 5 System wiring: HS-IR transmitter 6 Headphone battery replacement 7 Using HP-10 with a monitor with built-in IR audio transmitter 8 Troubles
General precautions Installation precautions Please read this manual completely and carefully prior to attempting to install your new mobile audio/video equipment. Installed correctly, your equipment will provide you with years of enjoyable and safe usage. Do not install components in areas which are susceptible to rain, moisture, direct sunlight, extreme heat or cold, excessive dust, dirt or humidity.
HS-IR and HP10 Headphone Controls and Features 1 4 2 3 5 6 1 5 IR SENSORS 2 VOLUME CONTROL KNOB 3 POWER ON/OFF SWITCH 4 POWER LED 6 BATTERY COVER See the section of this manual about battery replacement for more details. This button turns the headphone on and off. In addition, if headphones do not receive any infrared audio signal after a short period of time, they will shut off automatically to conserve battery life.
HS-IR Transmitter Features HS-IR 2 2 1 1 IR EMITTERS (AUDIO TRANSMITTERS) 2 MOUNTING HOLE HS-IR • HP10 User’s Manual - page 4
System wiring: HS-IR Transmitter Using the wires provided, complete the audio, and power connections in your vehicle as shown in the diagram below. Be sure to locate the transmitter in a location and position within direct line-of-sight of the location in the vehicle you plan to have passengers wearing headphones. AUDIO/VIDEO SOURCE (DVD player, video game, etc.
Installing or replacing headphone batteries The wireless headphones use (2) AAA batteries (not included), which are located in one of the earphone housings. To replace the batteries, follow the diagrams below. To conserve battery life, please be sure to turn off the headphones whenever they are not in use, even though they will turn off after a short period of interrupted IR reception. If you expect the headphones to be unused for several days, remove and store the batteries.
Using the HP10 headphones with a Boss Monitor Several video monitors include a wireless infrared transmitter. The transmitter sends a high-quality stereo signal which can be received the HP10 wireless infrared headphones. The infrared signal is emitted from the large dark lens on the front of the monitor console. Best sound will be obtained if you sit directly in front of the monitor within about six feet.
Troubleshooting If you experience operation or performance problems with this product, compare your installation with the electrical wiring diagram on the previous page. If problems persist, read the following troubleshooting tips which may help eliminate the problems. SYMPTOM No audio present in headphones. Sound is of poor quality or has interruptions and dropouts. CAUSE REMEDY Power cord is not properly connected.