WIRES CONNECTION Preface Thank you for purchasing this car audio product. Please read this manual carefully before operating this car audio product. Please keep this manual for future use. It will be helpful to you if you are encounter any operational problem. ANTENNA JACK Selecting fine audio equipment is only the start of your musical enjoyment. Now it is time to consider how to maximize the enjoyment you will get from knowing how to work your new car stereo receiver.
LOCATION AND FUNCTION OF CONTROLS TROUBLE SHOOTING 18 4 5 8 11 Before using the check list please make all the connections first. If you still have questions after going through the checklist, please consult your local customer service representative. 14 1 Common Symptoms Cause Solution The car ignition is switched off. If the power supply is properly connected to the car accessory, switch the ignition key to " ON " or " ACC " . There is no power. There is no sound.
BEEP ON/BEEP OFF BEEP ON mode: The beep is generated when any key is pressed. BEEP OFF mode: The beep sound is disabled. VOL LAST/VOL DEFA VOL LAST: The radio switches on at the actual volume it had when it was last switched off. VOL DEFA: After pressing SEL button, AVOL will be displayed. Then you can pre-select a constant switch-on volume by using the VOL knob. CLK ON/OFF CLK ON: Clock will always show on the display when power off. CLK OFF: Clock will disappear on the display when power off. 3 .
INSTALLATION METHOD This is an anti-theft installation method. The main unit wears a METAL MOUNTING SLEEVE. Please connect the wiring, eg, the Power supply, the Speakers and the Antenna according to the requirements of this Instruction Manual, then install the metal mounting sleeve into the car as per the diagram illustrated below. To properly fix the metal mounting sleeve, bend the tabs of the sleeve against the DASH BOARD with a screwdriver.
2) when press briefly, the radio searches for each preset station in the current band and holds at that preset number for 5 seconds with releasing mute, and then search again. During MP3/WMA file in disc or USB mode: 1) In TRACK SEARCH mode, the LCD will display TRK T 000 and flash the biggest digit 0 that the USBstick contain. (if the number of tracks is less than 100 and more than 9, it will be TRK 00) Then rotate the VOL knob to select the number of the flashing digit from 0 ~ 9.
OPERATION OF REMOTE CONTROL 1. Power On/Off. 1 2. Mute Button 4 3. SEL/MENU Button 4. Audio Level & Menu UP(+) Button 7 5. Audio Level & Menu Down(-) Button 6.Tune/Seek Up And Track Skip Up/FF Button 2 3 6 5 8 18. RELEASE BUTTON Press the REL button to release the front control panel from the unit chassis, then pull it up a little to remove from the unit chassis. When the front control panel is removed the LED indicator flashes. 19.