Service manual

– 21 –
KLV-26/32/40/46V300A
RM-GA008
2-1-7. Dress Conn Assy 20P (H1 wire) with
Slide Clamp
2-1-6. Dress Conn Assy 13P, 14P & 20P with
Clamp Edge (M)
2-1-9. Dress SP Conn Assy 4P with FG Clamp to
Top DTT shield
2-1-8. i) Apply sheet (Core) C on LCD panel
ii) Dress Conn Assy 20P with Tape (LCD)
Clamp Edge(M)
Connector Assy 20P
Connector Assy 14P
Connector Assy 13P
Connector assy 20P
(H1 wire)
Tape(LCD)
Make sure Connector assy 20P
is not tight when apply Tape LCD.
Sheet(Core)C
Connector assy 20P
(H3 wire)
SP Connector
Assy 4P
Make sure wire
is not trapped
when install Top
DTT to bottom
DTT shield
FG Clamp
Screw 3X8
End of UL tape as
reference line
Screw boss
Caution : Pull away from
screw boss
Connector Assy 20P
(H4 wire)
Screw boss
Caution : Pull away from
screw boss
2-1-11. i) Dress SP Conn Assy 4P with
G1 bracket's hook (2X)
ii) Dress Conn Assy 20P with
G1 bracket's hook (4X)
2-1-10. Dress SP Conn Assy 4P with
Slide Clamp (2X)