Service manual

– 28 –
KLV-26/32/40/46V300A
RM-GA008
2-3-12. Dress AC inlet wire with G3 bracket's
hook
2-3-11. i) Apply Sheet(Core)C on LCD panel
ii) Dress Connector Assy 20P
(H4 wire) with Tape(LCD)
2-3-14. Dress Connector Assy 2P with
G3 bracket's hook(2X)
2-3-13. i) Dress Connector Assy 20P with Slide
Clamp & Side Jack bracket's hook
ii) Screw Connector Assy 1P to the direction
2-2-16 i) Dress Connector Assy 7P with
G3 bracket's hook(5X)
ii) Dress Connector Assy 8P with
G3 bracket's hook(2X)
2-3-15. Connector Assy 2P NG example
Sheet(Core) C
Connector Assy 20P
(H4 wire)
Make sure Connector assy 20P(H4 wire)
is not tight when apply Tape LCD.
Tape(LCD)
AC inlet wire
Connector Assy 20P
Connector Assy 1P
Connector Assy 2P
60+/-5mm
Make sure Connector
Assy 2P with black UL
tape
is inserted to panel side.
OK
Caution :
Make sure Connector Assy 2P is
fully complete insert to panel &
D1 board
NG
NG
Over pull to bottom
Over pull to right
(Rear view)
Connector
Assy 8P
Connector Assy 7P