Service manual

– 32 –
KLV-26/32/40/46V300A
RM-GA008
2-4-18. i) Dress Connector Assy 13P with
D2 bracket's hook(1X)
ii) Dress Connector Assy 3P & 13P with
Sheet(Core)C(4X)
2-4-20. Make sure Connector Assy 1P is
keey away from heat sink
2-4-19. Screw Connector Assy 1P to the direction
2-4-17. i) Dress Connector Assy 7P with G3 bracket's hook(5X)
ii) Dress Connector Assy 8P with G3 bracket's hook(2X)
iii) Dress Connector assy 3P with G3 board's hook(2X) &
G3 bracket's hook(1X)
iv) Dress Connector Assy 13P with G3 bracket's hook(1X)
2-4-16. Dress Connector Assy 2P with D2 bracket's hook(3X) Connector Assy 2P NG example
Caution :
Make sure Connector Assy 2P is fully complete insert to panel & D1 board
Connector Assy 2P
Make sure Connector Assy 2P with black
UL tape is inserted to panel side.
Over pull to left
(Rear view)
Over pull to bottom
Connector Assy 3P
Connector Assy 7P
Connector Assy 8P
Connector Assy 13P
Connector Assy 8P
Connector Assy 13P
Connector
Assy 3P
Sheet(Core)C
Dress
Connector
assy 3P
above this line
Sheet(Core)C
Connector Assy 1P
Connector Assy 1P
Heat Sink
NG
NG
OK
50+/-5mm