USER’S MANUAL RF WIRELESS REMOTE RGB LED CONTROLLER POWERSPORTS
1
RF Wireless Remote Ad van ce d RGB LED Controller Instructions • • • • • 22 Dynamic Modes 20 Static Colors Very Smooth Effects Speed Adjustable Brightness Adjustable • • • • • Card Type RF Remote Ultra Slim Design Dynamic Demo Mode Easy Remote Pairing Direct Color Select 2
Functions 1 2 3 3 9 4 7 5 6 10 8
1. Turn On/Standby Mode Press this key to turn on unit or switch to Standby Mode. 2/8. Dynamic Mode Adjust Switch to Dynamic Mode from static color, or switch between Dynamic Modes. 3/9. Dynamic Speed Adjust Adjust Dynamic Playing Speed. Press SPEED+ to increase speed and press SPEED- to decrease. Unit will switch to Dynamic Mode, if this key is pressed during Static Color Mode. 4/5. Static Color Adjust Switch to Static Color Mode from Dynamic Mode, or press COLOR+ or COLORto change colors. 6/7.
10. Demo Mode Pressing this key will switch to Demo Mode. In Demo Mode, it plays 12 Dynamic Modes in loop, each mode repeats 3 times. Installing 1. Power Supply Operational voltage is 12V DC, negative ground. The DC jack’s inner pole (or red cable) is positive and sleeve (or black cable) is negative. Also, please make sure the power supply voltage is same as the LED load. 2. LED Output This unit supports common anode connection LED products. The mark ‘ ’ indicates the common connection node.
CAUTION! Do not short circuit or overload the LED outputs, this may lead to permanent damage! 2 RGB LED + 5-24V – LED CONTROLLER RF Remote / Easy Color / Switchable Peak Output Current : 3x4A 189 Common Node 1 + – Operation 1. Using Remote Controller Please pull out the battery insulation tape before using. The RF wireless remote signal can pass through barrier, so it’s not necessary to aim at the main unit when operating.
For proper receiving remote signal, please do not install the main unit in closed metal parts. 2. Pairing New Remote The remote and main unit is 1 to 1 paired as default. Furthermore, main unit can be paired to 3 remote controllers and each remote controller can be paired to any main unit. Please do following steps to pair new remote controller: 1). Plug off the power of main unit and plug in after 5 seconds. 2). Press ‘SPEED-’ and ‘SPEED+’ Key together in seconds after power on.
2). Press ‘ON/OFF’ and ‘MODE+’ Key together 5 seconds after powering on. After this operation, the main unit will recognize any remote control. To pair the main unit back to specific remote, please repeat the ‘pairing New Remote’ operation. 4. Switch Output Color Sequence The controller’s default output signal sequence is Common-Green-Red-Blue. If the LED application is in different cable sequence, the direct color keys will not match the LED color.
Specifications Dynamic mode Static Color PWM Grade Brightness Grade Speed Grade Demo Mode Direct Color Select Output Color Switchable Operational Voltage Output Current Remote Frequency Remote Distance 9 22 modes 20 colors 256 levels 5 levels 10 levels Yes Yes Yes, 6 options 12V DC, negative ground 3x4A peak, 3x2A constant 433.
NOTES 10
USER’S MANUAL RF WIRELESS REMOTE RGB LED CONTROLLER BOSS Audio Systems 3451 Lunar Court • Oxnard, CA 93030 www.bossaudio.com 800-999-1236 US Toll-free 805-751-4853 Customer Service Tech Support: www.bossaudio.
