User Manual

22
Switching the Direct Sound On and Off
When the CE-20 is connected to a mixer’s or multitrack recorder’s sends or returns,
you can then elect to output only the chorus sound, with the direct sound turned
off.
Use the following steps to turn the direct sound on and off.
1. Switch off the power.
• When running on battery power:
Disconnect the connection plug from the INPUT R (MONO) jack.
• When running on power from an AC adaptor:
Disconnect the plug from the AC ADAPTOR jack.
2. While holding down the EFFECT ON/OFF pedal, switch on the power.
• When running on battery power:
Insert the connection plug into the INPUT R (MONO) jack.
• When running on power from an AC adaptor:
Insert the AC adaptor plug into the AC ADAPTOR jack.
When the pedal is released, the MEMORY number indicators 1 and 2 flash.
3. Press the EFFECT ON/OFF pedal to set the direct sound to ON or OFF.
EFFECT ON/OFF indicator lit: direct sound is output.
EFFECT ON/OFF indicator off: direct sound is not output.
4. Press the WRITE button.
After the MEMORY number indicators 1 and 2 begin flashing rapidly, the setting is
stored in memory and the unit returns to its ordinary state.
* To cancel the setting change and the unit returns to its ordinary state, then before you
press the WRITE button, operate the MANUAL/MEMORY pedal.