User Manual

8
Editing: Eects
Writing Patch Settings into a STOMPBOX
1. Press the [EFFECT] button.
2. Use the [SELECT] knob to choose the eect you’re going to
save.
3. Use the PAGE [
K
] [
J
] buttons to move to the last page.
4. Press the [5] knob.
The STOMPBOX select window appears.
5. Press the [4] (WRITE TO STOMPBOX) knob.
6. Turn knob [1] to select the writing-destination STOMPBOX.
7. Use knobs [3]–[5] and [SELECT] knob to name the
STOMPBOX.
You can turn the [SELECT] knob to move the cursor within the
name.
Reference
For details on naming the STOMPBOX, refer to “Editing a
name” (p. 8).
Saving a Patch
When you want to save a patch you have created, save it as a
user patch by following the procedure below. If you do not save
the patch, the edited settings will be lost when you turn o the
power or switch to another patch.
1. Press the [WRITE] button.
2. Press knob [1] to select “WRITE” (PATCH WRITE).
3. Use knob [1] to select the save-destination (U001–U250).
You can use knobs [3]–[5] and [SELECT] knob to edit the name.
Editing a name
To edit the patch name, use knob [SELECT] to move the cursor
and use knob [5] to change the character.
Controller Operation
Turn the [3] knob Selects the type of characters
Press the [3] knob Delete one character (delete)
Turn the [4] knob Switch uppercase/lowercase
Press the [4] knob Insert one space (insert)
Turn the [5] knob Changes the character
Turn the [SELECT] knob Moves the cursor
4. Press the [WRITE] button once again.
The patch is written.