User manual

14
Connecting to Your Computer via USB
Using LOOP FX
You can apply an eect to the phrase playback. The eect
will be applied in synchronization with the tempo of the
phrase.
* You can’t apply an eect to the sound being
recorded (i.e., you can’t record the processed signal).
* The eect will be applied to both tracks 1 and 2.
Turning LOOP FX On/O
1. Press the [LOOP FX ON/OFF] button to
turn LOOP FX on/o.
While stopped or playing, you can turn LOOP FX on/
o by pressing the left pedal twice in succession.
Specifying the LOOP FX Type
1. Press the [LOOP FX TYPE] button to
select the desired LOOP FX type.
LOOP FX Type Explanation
BEND DOWN This eect abruptly lowers the pitch.
STEP PHASER This is a phaser that changes in steps.
SWEEP FILTER
This is a lter whose frequency changes
in synchronization with the tempo.
TEMPO DELAY
This produces a tempo-synchronized
delay eect.
Lo-Fi
This eect intentionally degrades the
sound to create a distinctive character.
You can connect the RC-30 to your computer via a com-
mercially available USB cable, and back up RC-30 phrases
(WAV les) to your computer or load WAV les from your
computer to the RC-30.
Playable WAV le formats
Data Format
WAV
Bit Rate
16-bit linear, stereo
Sampling Frequency
44.1 kHz
Maximum WAV le size is 1.7 GB (total of all les), maximum
time is approximately 3 hours (total of all phrases), and
minimum time is approximately 1.5 seconds.
1. Turn on the RC-30’s power (insert a plug
into the OUTPUT L jack).
* The RC-30 will not operate on USB bus power.
We recommend that you use an AC adaptor (sold
separately) to ensure that the power does not turn
o while connected via USB.
2. Use a commercially available USB cable
to connect the RC-30’s USB connector
to your computer’s USB connector
(a connector that supports USB 2.0
Hi-Speed).
The display will indicate “Cn.”
* You can’t make USB connections if the RC-30 is not
stopped, or if there is a phrase that has not been
saved.