User Manual

34
Settings Made When the Power is Switched ON
Returning Settings to Their Factory Defaults
You can restore the following settings to their original factory values.
Carrying out the following procedure completely clears the content currently
stored in the memories (1-4).
1. Switch off the power.
2. While holding down the WRITE button, switch on the power.
The MEMORY Number indicators (1-4) flash.
fig.50
3. Press the WRITE button.
After the MEMORY Number indicators (1-4) begin flashing rapidly, the setting is
stored in memory and the unit returns to its ordinary state.
* To cancel the setting change and the unit returns to its ordinary state, then before you
press the WRITE button, operate the MEMORY/TAP or ON/OFF pedal.
Memory Settings
Memory 1 (p. 12) SMOOTH
Memory 2 (p. 12) TAPE
Memory 3 (p. 12) DUAL
Memory 4 (p. 12) MODULATE
MANUAL Delay Time (p. 9)
(when the power is switched on)
MANUAL: 300 msec
DUAL Short Delay Time (p. 24) S: 50
MODULATE Rate/Depth (p. 25) r: 80, d: 70
TAPE (p. 23) HEd1
Pedal Mode (p. 29) Mode 1
Output Mode (p. 30) Mode 1
External Pedal Function (p. 31) TAP
MEMORY Number Indication (p. 33) Lighting Pattern 1