User Manual
Table Of Contents
- Getting Ready
- Basic Operation
- Editing a Patch
- Saving a Patch
- Parameter List
- Convenient Functions
- Synchronizing with a DAW or External MIDI Device
- Assigning a Function to an External Pedal
- Restoring the Factory Default Settings
- Transmitting Data to an External MIDI Device
- Troubleshooting
- Main Specifications
- USING THE UNIT SAFELY
- IMPORTANT NOTES
12
Parameter List
PATCH
Parameter Explanation
MODE Selects the type of delay (p. 5). The same function as the [MODE] knob.
TIME Species the delay time. The same function as the [TIME/VALUE] knob.
BPM Species the tempo.
NOTE Species the delay time with the note length relative to BPM.
FEEDBACK
Adjusts the feedback level (or how much the sound is repeated). Higher settings will result in more delay
repeats. The same function as the [FEEDBACK] knob.
TONE Adjusts the tone of the delay sound. The same function as the [TONE] knob.
EFFECT LEVEL Adjusts the volume of the delay sound. The same function as the [E. LEVEL] knob.
MOD DEPTH Adjusts the modulation depth of the delay sound. The same function as the [MOD DEPTH] knob.
MOD RATE Adjusts the modulation rate of the delay sound.
CARRY OVER You can specify whether the eect sound is carried-over when you switch patches or turn the delay o.
DIRECT LEVEL Adjusts the volume of the direct sound when the eect is on.
EQ SW Turns the EQ on/o.
EQ LO.CUT
Sets the frequency at which the low cut lter begins to take eect.
When “FLAT” is selected, the low cut lter will have no eect.
EQ LO.GAIN Adjusts the low frequency range tone.
EQ LM.GAIN Adjusts the low-middle frequency range tone.
EQ LM.FREQ Species the center of the frequency range that will be adjusted by the LM.GAIN.
EQ LM.Q Adjusts the width of the area aected by the EQ centered at the LM.FREQ. Higher values will narrow the area.
EQ HM.GAIN Adjusts the high-middle frequency range tone.
EQ HM.FREQ Species the center of the frequency range that will be adjusted by the HM.GAIN.
EQ HM.Q Adjusts the width of the area aected by the EQ centered at the HM.FREQ. Higher values will narrow the area.
EQ HI.GAIN Adjusts the high frequency range tone.
EQ HI.CUT
Sets the frequency at which the high cut lter begins to take eect.
When “FLAT” is selected, the high cut lter will have no eect.
EQ LEVEL Adjusts the overall volume level of the equalizer.
LO DAMP Adjusts the amount by which the low frequency range is reduced each time the eect sound is repeated.
LO DAMP F Species the frequency of the low range that is reduced by LO DAMP.
HI DAMP Adjusts the amount by which the high frequency range is reduced each time the eect sound is repeated.
HI DAMP F Species the frequency of the high range that is reduced by HI DAMP.
DUCK SENS
Adjusts the sensitivity at which the volume is automatically adjusted according to the input. Higher values
allow the adjustment to occur in response to lower volumes.
DUCK PRE DEPTH
The volume being “input” to the delay is automatically reduced when the input sound is loud. The amount of
reduction increases as this setting approaches 100.
DUCK POST DEPTH
The volume being “output” to the delay is automatically reduced when the input sound is loud. The amount
of reduction increases as this setting approaches 100.
EFFECT PAN Adjusts the stereo position of the eect sound.
DIRECT PAN Adjusts the stereo position of the direct sound.