User Manual

22
Assigning a Function to an External Pedal
You can assign a function to a footswitch (sold separately: FS-5U, FS-5L, FS-6, FS-7) or expression
pedal (sold separately: Roland EV-5 etc.) connected to the CTL 1,2/EXP jack.
1. Press the [EDIT] button.
2. Use the [
H
] [
I
] buttons to select “CONTROL,” and then press the
[EDIT] button.
3. Use the [
H
] [
I
] buttons to select a parameter, and use the [TIME/
VALUE] knob to edit the value.
Parameter Value Explanation
PREF
PATCH Dierent settings can be made for each patch.
SYSTEM The same settings are shared by all patches.
FUNC Specify the function of the footswitches connected to the CTL 1,2/EXP jack.
MODE
MOMENT
The switch is normally o (minimum value), and turns on
(maximum value) only while you hold it down.
TOGGLE
The switch alternately switches o (minimum value) and on
(maximum value) each time you press it.
CTL1 FUNC and CTL2 FUNC Settings
Value Explanation
OFF No function is assigned Select this if you’re using the ASSIGN 1–8 setting (p. 15).
TAP Use the switch for tap input.
HOLD Repeats the delay sound while you hold down the switch.
WARP
Simultaneously controls the delay sound’s feedback level and volume to produce a totally unreal
delay.
TWIST A new type of delay that produces an aggressive, spinning sensation.
MOMENTARY Outputs the delay sound only while you hold down the switch.
ROLL 1/2 Cuts the delay time to 1/2 the setting only while you hold down the switch.
ROLL 1/4 Cuts the delay time to 1/4 the setting only while you hold down the switch.
ROLL 1/8 Cuts the delay time to 1/8 the setting only while you hold down the switch.
FADE IN
Fades-in/-out the delay sound.
FADE OUT
EFFECT SW Turns the eect on/o.
BANK UP
Change banks.
BANK DOWN
LOOPonO Enter/Exit the Phrase Loop Mode.
LOOP CLEAR Erase the phrase.