User Manual
Table Of Contents
- Getting Ready
- Basic Operation
- Editing a Patch
- Saving a Patch
- Parameter List
- Convenient Functions
- Synchronizing with a DAW or External MIDI Device
- Assigning a Function to an External Pedal
- Restoring the Factory Default Settings
- Transmitting Data to an External MIDI Device
- Troubleshooting
- Main Specifications
- USING THE UNIT SAFELY
- IMPORTANT NOTES
4
Getting Ready
Turning the Power On
* Once everything is properly connected (p. 2), be sure to follow the procedure below to turn
on their power. If you turn on equipment in the wrong order, you risk causing malfunction or
equipment failure.
1. Insert a plug into the INPUT A/MONO jack.
The DD-500 power turns on.
2. Turn on the power of your guitar amp or other equipment.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the
unit on is required before it will operate normally.
* Before turning the unit on/o, always be sure to turn the volume down. Even with the volume
turned down, you might hear some sound when switching the unit on/o. However, this is
normal and does not indicate a malfunction.
* When turning the power o, do so in the reverse order.