User Manual

13
Troubleshooting
The power won’t come on/
the CHECK indicator doesn’t light
● Is the specified adaptor (PSA-series,
sold separately) properly connected?
Check the AC adaptor connection (p. 7, p. 8).
* Never use any AC adapter other than one specified
for use with the FBM-1.
● Is the battery low or dead?
Replace it with a new battery (p. 12).
* The battery that is supplied with the unit is for
temporary use, intended primarily for testing the
pedal’s operation.
* The use of an AC adaptor is recommended as the
unit’s power consumption is relatively high. Should
you prefer to use a battery, please use the alkaline type.
* To prevent unnecessary battery consumption, be sure to
disconnect the plug from the INPUT jack and the
BRIGHT IN jack when not using the effects unit (p. 5).
● Is your guitar properly connected to the
INPUT (or BRIGHT IN) jack?
Check the connection once more (p. 7, p. 8).
* A cable must be connected to the INPUT jack (or
BRIGHT IN jack) to allow the effect to be turned on.
* If a cable is connected but no power is supplied to
the unit (either from a battery or an AC adaptor),
the CHECK indicator will not light when you try to
turn the effect on.
No sound / low volume
● Is your instrument properly connected
to the FBM-1?
Check the connection once more (p. 7, p. 8).
● Is the LEVEL knob set too low?
The further counterclockwise you turn the
LEVEL knob, the more the volume is re-
duced when the effect is on. Turn the LEVEL
knob clockwise to increase the volume.
● Is the volume turned down on any guitar
amp or effects device you have connect-
ed?
Check the settings of the connected device.
● Is the battery low or dead?
Replace it with a new battery (p. 12).
FBM-1_e1.book 13 ページ ２００７年５月１０日 木曜日 午前１０時４３分