User Manual

5
Panel Descriptions
2. CHECK Indicator
This indicator shows whether the effect is on
or off, and also doubles as the battery check
indicator. The indicator lights when the ef-
fect is on.
* If you’re powering the unit with a battery and
the CHECK indicator goes dim—or doesn’t
light at all—when you try to turn the effect on,
the battery is near depletion and should be
replaced. For instructions on changing the
battery, refer to “Changing the Battery” (p. 12).
* The CHECK indicator shows whether the effect
is being applied or not. It does not indicate
whether the power to the device is on or not.
3. OUTPUT Jack
This output jack is used for connecting to
guitar amps and other effects processors.
4. Pedal Switch
This switch turns the effect on/off.
5. Thumbscrew
When this screw is loosened, the pedal will
open, allowing you to change the battery.
For instructions on changing the battery, re-
fer to “Changing the Battery” (p. 12).
6. INPUT Jack, BRIGHT IN Jack
These jacks are for connecting the output
from an electric guitar or other instrument or
effects device.
Using the BRIGHT IN jack makes the treble
range more prominent.
* These jacks double as power switch. Power to
the FBM-1 is turned on when you plug into
the INPUT/BRIGHT IN jack; the power is
turned off when the cable is unplugged.
When not using the FBM-1, be sure to
disconnect the plug from the INPUT/
BRIGHT IN jack.
* INPUT is disabled when the BRIGHT IN
jack is used.
FBM-1_e1.book 5 ページ ２００７年５月１０日 木曜日 午前１０時４３分