Owner's Manual

INSTALLATION(CONT.)
- Only use speakers with 4 ohms impedance.
- Do not attach the control panel to the chassis before wiring is complete.
- The maximum current of the Amp Remote trigger is 200mA.
Wiring Connections
WIRING
DIAGRAM
White:Front Left PRE- AMP Output
Red : Front Right PRE - AMP Output
Red: Rear Right PRE - AMP Output
White: Rear L eft PRE-AMP Output
Purple+
Rear Right Speaker l)====l
Purple / Black -
Gray+
I I I I
I I I I
I I
I I
t
f1sAMP~
H--- -- FUSE REPLACEMENT
WITH ATO TYPE ONLY
L======<I Rear Left Speaker
Green/Black -
CAUTION
+12V DC
NEGATIVE
GROUND
White +
Front Right Speaker ll==== l=======<I Front Left Speaker
ACC + (Red)
GND - (B lack )
ANT+ (B lu e)
Power B + (Yellow)
Gray/Black - White / Black -
Uninstall the Main Unit
1. Remove the plastic trim out from the main unit.
2. Insert a bracket key into the left and right side of the main unit and draw the unit out of
the mounting sleeve.
-