Owner's Manual
3.
To
adjust the volume level
Rotate the VOL knob to adjust the volume level during playback.
4.
To
mute
or
resume the sound
Press the MUTE button to eliminate or resume the sound immediately during playback.
To
resume the sound immediately, user can also rotate the VOL knob.
5.
To
select and adjust the mode of the sound and menu
A)
To
select and adjust the sound mode:
Press SEL button shortly and repeatedly to select the mode
of
VOL(volume
),
BAS(bass
),
TRE(treble
),
BAL(balance) and FAD(fader)
in
the sequence and circulation.
In
each mode, the waiting time is about 5 seconds, and when the waiting time is over, it will return to
the last display mode.
After select a desired sound item, rotate VOL knob to adjust level
of
the selected sound item.
B)
To
select and adjust the menu mode:
Press SEL button and hold for about 2 second to turn on MENU mode, and the LCD will display
INVOL, then press SEL button repeatedly to select DSP/BEEP (ALL/OFF/2ND)/TAVOL/EON
CON/OFF) /REG CON/OFF) /AF(ON/OFF)/TA(ON/OFF) /EQ CON/OFF)/LOUD(ON/OFF)/LOC
CON/OFF, only for
FM
mode) /MONO/STEREO(only for
FM
mode) /AREA(EURIUSA)
After selecting a desired mode, rotate the VOL knob to select one setup item
of
the desired mode.
DSP:
in
this mode, you can set the clock time. Rotate the VOL knob clockwise/counter clockwise to
adjust the hours/minutes.
BEEP ALL: the beep is generated when every key is pressed( except the power button, REL key and
EJECT key).
BEEP 2ND: the beep
is
only generated when an allotted double key
is
pressed long(1second).
BEEP OFF: the beep sound
is
disabled.
TAVOL: This function is to set the
TA
volume level from 0-45. When TA function is activated, if a TA
program is tuned
in
at the volume level set regardless
of
the volume
of
the other source at
the time.
EON:
In
RDS mode, when EON is ON, the EON programs will scan automatically.
Select EON OFF to ·stop the scan.
LOUD: When the volume level
is
below half level, select LOUD
ON
mode to enhance bass sound. It is
advised that LOUD ON mode not be select when the volume level is high.
LOC: LOC ON mode improves reception
in
some areas where the signal is too strong.
(Note:LOC function only for
FM
mode.)
STEREO/MONO: Select STEREO mode to improve the sound effect. Select MONO mode to
decrease noise and make the sound more clear when the station signal
is
weak.
6.
To
reset the system
Before operating the unit for the first time,
or
after replacing the car battery or changing the connections,
you must reset the unit,
Press the RESET button with a cuspidal object. This operation will erase the clock setting and some
stored contents.
7.
To
remove the front panel
Press the REL button to flip down the front panel from the unit chassis, then pull it up a little to remove jt
from the unit. And the anti-theft LED indicator will flash all the time till the front panel is assembled back.
4