User Manual

6
Panel Descriptions (Nextone Stage / Artist)
Connecting a Footswitch
(Sold Separately)
Connecting the BOSS FS-6, FS-7, or FS-5L
CH SELECT/BOOST jack
* Pin assignment of FOOT CONTROL jack
Stereo 1/4” phone type
Stereo 1/4” phone type
or
FS-5L
RING
RING
TIP
TIP
RING TIP
FS-6 FS-7
Rear panel
Stereo 1/4” phone type
1/4” phone type x 2
or
Switch Explanation
TIP Switches between CLEAN channel and LEAD channel.
RING Turns the BOOST on/o.
* The Nextone is compatible with latch-type footswitches (FS-6, FS-
7, FS-5L). If you’re using an FS-6 or FS-7, set the mode of A and B to
FS-5L (LATCH). Momentary-type footswitches (e.g., FS-5U) cannot
be used.
DELAY jack
Turns the DELAY on/o.
Rear panel
1/4” phone type
,
1/4” phone type
Connecting the GA-FC
Connect a stereo cable to the GA-FC jack.
* Always use a stereo cable.
* Use cables that do not contain resistors.
GA-FC
Using the GA-FC
You can switch between CLEAN and LEAD. You can also switch the
BOOSTER, TONE, EFFECT LOOP (EFX LOOP), and DELAY on/o.
Ax the included adhesive labels to the GA-FC.
Using the expression pedals
If you connect an expression pedal (sold separately: Roland EV-5,
BOSS FV-500L, BOSS FV-500H), you can use the pedal to vary the
volume.
GA-FC
Expression Pedal
Jack Explanation
TAP/INPUT
Adjusts the guitar’s signal level that is input to the
preamp.
VOLUME Adjusts the master volume.
Setting MINIMUM VOLUME of an expression pedal
With the
[MINIMUM VOLUME] knob
of an expression pedal, you can set
the value for when the pedal is lifted
up all the way (lowest value).
* Use only the specied expression
pedal. By connecting any other expression pedals, you risk causing
malfunction and/or damage to the unit.
MEMO
If a footswitch (sold separately: FS-5U) is connected to the rear
panel TAP/INPUT jack, you can use it to set the delay time just as you
operate the
[TAP] button (p. 4).
1/4” phone type
,
1/4” phone type
TIP
RING
SLEEVE (GND)
[MINIMUM
VOLUME] knob