User Manual

Basic Operation Guide
7
Deutsch
Français Italiano Español
Português
Nederlands
EnglishEnglish
AUX IN jack
Use a stereo mini-plug cable to connect your
audio player here.
To adjust the input level of the AUX jack,
adjust the controls of the connected device
(e.g., audio player).
Phones jack
Connect a set of headphones (sold separately) here.
MEMO
You can adjust the volume of the headphones (p. 13).
Outputting the Rhythm Only to Headphones
You can use the rhythm as a click tone, and output it only to the
headphones. For details, refer to “Parameter Guide” (PDF).
Auto O Settings
When ten hours have passed since you last played or operated the
RC-202, the power turns o automatically (with the factory settings).
If you don’t need the power to turn o automatically, turn the Auto O
setting “OFF.”
1. Press the [SETUP] button.
2. Press the [DELAY] (GENERAL) button.
3. Press the [VALUE] knob to select “AOF.”
4. Turn the [VALUE] knob to change the value.
OFF
The power will not turn o automatically.
ON
The power will automatically turn o when
10 hours have passed since you last played or
operated the RC-202.
5. Press the [SETUP] (EXIT) button to complete the setting.
Phantom Power Setting
If you’re using a condenser microphone that requires phantom
power, turn phantom power on as described below.
1. Press the [SETUP] button.
2. Press the [BEAT] (I/O) button.
3. Press the [VALUE] knob to select “V48.”
4. Turn the [VALUE] knob to select “ON.”
5. Press the [SETUP] (EXIT) button to complete the setting.
* WARNING: Precautions concerning use of phantom
power supply. Always turn the phantom power o
when connecting any device other than condenser
microphones that require phantom power.
You risk causing damage if you mistakenly supply phantom power
to dynamic microphones, audio playback devices, or other devices
that don’t require such power. Be sure to check the specications
of any microphone you intend to use by referring to the manual
that came with it. (This instrument’s phantom power: 48 V DC, 10
mA Max)
Caution when turning o the power
While the RC-202 is in the following states, you must
never turn o the power. Doing so may cause all the saved
data to be lost.
5 While recording/overdubbing/playing back
5 While undoing/redoing
5 While switching/saving/deleting a phrase memory
5 While a factory reset is in progress
5 While connected to a computer
Caution when using a microphone
If the speakers and microphone are close together, the
sound played back from the speakers may be picked up by
the microphone. If you record or overdub in such a state, the
speakers playback picked up by the microphone will also be
recorded. You should separate the speakers and microphone
so that the playback from the speakers is not picked up by
the microphone.
Turning On the Power
When powering up Turn on the power to your amp last.
When powering
down
Turn o the power to your amp rst.
1. Turn the [POWER] switch ON.
MEMO
You can adjust the output volume (
p. 13).